Refer to the video in the link to add a LONGER printer The following link is the video of adding a LONGER printer to cura4.8 or 4.9. The official website link is as follows:ģ.After pasting the pins of the USB cable with tape, you can connect the printer to the computer, and then you need to update the printer's firmware through the slicing software cura.Ĥ.Cura software version 4.8 or 4.9 does not add a LONGER printer by default. If the pins are not attached, the printer will not work properly use.Ģ.To connect the computer to the printer, you need to install the driver, which can be installed on the LONGER official website. A Detail Guide about LONGER LK5 Pro Upgrades and How to Upgrade LONGER LK4 Pro in Easy Stepsġ.Since the motherboard of the LK4 Pro, LK5 Pro printer is an open source motherboard, use electrical tape to paste the pins on the side of the USB cable socket before connecting to the computer to isolate the computer from supplying power to the printer motherboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |